Electrolux ERD1843 Manuale Utente Scaricare il pdf (Pagina 15)

Change of door opening direction

Should the setting-up place or handling demand it, door-

opening direction can be refitted from right-handed to left-

handed.

Appliances on the market are right-handed.

Following operations are to be done on the basis of fig-

ures and explanations:

Disconnect the appliance from the electricity supply.

Tilt back the appliance carefully. It is recommended to

ask another person for help, who can keep the appli-

ance at this position safely.

Unscrew on the both sides adjustable feet (2 pieces)

and the fixing screws (2 pieces) of bottom door holder

and the far side screws (2 pieces) too.

Take off the door of the refrigerator by pulling it slightly

downwards.

Dismount the double door holder by removing the

screws (2 pieces).

Take off the door of the freezer by pulling it slightly

downwards.

Unscrew the top door holding pin of the freezer, then

screw it back on the other side.

Remove the covering nails of the double door holder

on the left side and put them to the other side.

Fit the door of the freezer to the top door holding pin.

Fix the double door holder onto the left side using the

screws (2 pieces). Be careful that the door edge of the

freezer is parallel with the edge of the mantle.

Fit the door of the refrigerator to the double door hold-

ing pin.

Fix the bottom door holder onto the left side using the

screws (2 pieces) and the adjustable foot as well as

screw the 2 pieces screws on the opposite side into

the vacant holes. Be careful that the door edge of the

refrigerator is parallel with the edge of the mantle.

Put over the handle on the opposite side and cover up

the vacant holes with the plastic nails from the bag of

instruction book.

After released the screws the adaptation of the doors

can be adjusted with the horizontal control of central

door holder.

Put the appliance to its place, set it level and connect

to the electricity supply.

In case you do not want to perform the procedures above,

call the nearest brand-mark service. Technicians will

accomplish the refitting expertly for charge.

Electrical connection

This refrigerator is designed to operate on a 230 V

AC (

) 50 Hz supply.

The plug must be put into a socket with protective

contact. If there is no such, it is recommended to get

an electrician to fit an earthed socket in compliance

with standards near the refrigerator.

This appliance complies with the following E.E.C.

Directives:

- 73/23 EEC of 19.02.73 (Low Voltage Directive) and

subsequent modifications,

- 89/336 EEC of 03.05.89 (Electromagnetic

Compatibility Directive) and subsequent modifications.

1 2 ... 10 11 12 13 14 15 16 17 18

Commenti su questo manuale

Nessun commento

Electrolux ERD1843 Manuale Utente Pagina 15

Commenti su questo manuale

Prodotti e manuali riguardandi no Electrolux ERD1843