Electrolux EGT6345YOK Manuale Utente Scaricare il pdf (Pagina 14)

8.4 Injectors replacement

1. Remove the pan supports.

2. Remove the caps and crowns of the

burner.

3. With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Technical

Information" chapter).

4. Assemble the parts, follow the same

procedure backwards.

5. Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied with

the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure

adjuster on the gas supply pipe.

8.5 Adjustment of minimum level

To adjust the minimum level of the

burners:

1. Light the burner.

2.

Turn the knob on the minimum

position.

3. Remove the knob.

4. With a thin screwdriver, adjust the

bypass screw position (A).

A

5. If you change:

• from natural gas G20 20 mbar to

liquid gas, fully tighten the bypass

screw in.

• from liquid gas to natural gas G20

20 mbar, undo the bypass screw

approximately 1/4 of a turn.

WARNING!

Make sure the flame does not

go out when you quickly turn

the knob from the maximum

position to the minimum

position.

8.6 Electrical connection

• Do not pull the mains cable to

disconnect the appliance. Always pull

the mains plug (if applicable).

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the

cabinet, in order to avoid any contact

with the equipment beneath the

cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety the installation must be

done by a qualified electrician (e.g. your

local Electricity Board, or a contractor who

is on the roll of the National Inspection

Council for Electrical Installation

Contracting [NICEIC]).

The manufacturer refuses

to be held responsible, if

these safety measures are

not abided by.

Supply connections

This hob has to be connected to 230 —

240 V ( 50 Hz) electricity supply.

The hob has a terminal block which is

marked as follows:

• L — Live terminal

• N — Neutral terminal

•

or E — Earth terminal

Before carrying out the connection, make

sure:

1. The limiter valve and the electrical

system can take the appliance load

(see the rating plate)

2. The supply system is equipped with

an efficient earth connection in

compliance with the current standards

and regulations

3. The outlet or omnipolar switch used

for connection is easily accessible with

the appliance installed.

www.electrolux.com14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Commenti su questo manuale

Nessun commento