Electrolux EGG7355NOX Manuale Utente

EGG7355... ...EN HOB USER MANUAL

Problem Possible cause RemedyThe gas ring burns un-evenly• Burner crown isblocked with food resi-dues• Make sure that the in-jector is not blockedand

8. INSTALLATIONWARNING!Refer to "Safety information"chapter.WARNING!The following instructions aboutinstallation, maintenance and ven-tilati

AA)The by-pass screw• If you change from natural gas G20 20mbar to liquid gas, fully tighten the ad-justment screw in.• If you change from liquid gas

10 mm86 mm86 mmA3 mmABA)supplied sealB)supplied bracketsCAUTION!Install the appliance only on aworktop with flat surface.If you install the hob under

Heat inputRapid burner: 2.2 kWSemi - rapid burner: 1.65 kWTOTAL POWER: G20 (2H) 20 mbar = 9.35 kWG30 (3+) 28-30 mbar = 654 g/hG31 (3+) 37 mbar = 643 g

ENGLISH 15

www.electrolux.com/shop892953121-B-322012

CONTENTS1. SAFETY INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 32. SAFETY INSTRU

1. SAFETY INFORMATIONBefore the installation and use of the appliance, carefullyread the supplied instructions. The manufacturer is notresponsible if

• Never try to extinguish a fire with water, but switch offthe appliance and then cover flame e.g. with a lid or afire blanket.• Do not store items on

nect the appliance from the mains at allpoles. The isolation device must have acontact opening width of minimum 3mm.• Use only correct isolation devic

• Do not clean the burners in the dish-washer.• Clean the appliance with a moist softcloth. Only use neutral detergents. Donot use abrasive products,

Always light the burner before youput cookware.To light the burner:1.Turn the control knob counterclock-wise to the maximum position ( ) and push it

Burner Diametersof cookwareSemi-rapid (front right) 120 - 200mmSemi-rapid (front left) 120 - 200mmWARNING!Do not put the same pan on twoburners.WARNIN

can remove stubborn stains with apaste cleaner.• After you clean the pan supports, makesure that they are in correct positions.• Make sure that the ar