Electrolux EHT7833K Manuale Utente Scaricare il pdf (Pagina 40)

40 electrolux

• The following instructions about installation and maintenance must be

carried out by qualified personnel in compliance with the regulation in

force. The regulation to be applied for this type of installation is NBN D

5I.003 : "Installations functioning with combustible gas lighter than air".

• The side walls of the unit in which the hob is going to be installed, must

not exceed the height of the working top.

• Avoid installing the appliance in the proximity of inflammable materials

(e.g. curtains, tea towels etc.).

• The appliance must be electrically disconnected before all interventions.

If any electric supply to the appliance is required to carry out the work,

ensure all the necessary precautions are followed.

Gas connection

It is indispensible that the connection to the gas mains are carried out by means of

an AGB tap. Choose fixed connections or use a flexible pipe in AGB (stainless steel).

If using flexible metallic pipes, be careful they do not come in contact with mobile parts

or they are not squeezed. Use the same attention when the hob is combinated with

an oven.

This hob can be operated by Slochteren gas (G25) with a nominal pressure of 25 mbar

or by natural gas with nominal pressure of 20 mbar. No regulation is required for use

by these two types of gas. Before fitting the appliance ensure that the installation has

the correct voltage for the appliance. At full capacity, the drop in pressure

must not exceed 5%. Such a drop in pressure

is caused by the following parameters:

- maximum capacity of meter;

- diameter and lenght of the tube in front and

behind the meter;

- section of transit of variuos tubes positioned

on the circuit;

- diameter of eventual connections.

IMPORTANT - To ensure a correct operation,

a saving of energy and the long-life of the

appliance, the voltage pressure of the appliance

must correspond to the recommended values.

The adjustable connection is fixed to the

comprehensive ramp by means of a threaded

nut G 1/2".

All the components shown in the diagram

have already been assembled in the factory.

The appliance, before leaving the factory, has been tested in order to give you the

best results.

Instruction for the Installer

A) Ramp with ending nut

B) Seal

C) Adjustable connection

FO 2365

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 51 52

Commenti su questo manuale

Nessun commento

Electrolux EHT7833K Manuale Utente Pagina 40

Commenti su questo manuale

Prodotti e manuali riguardandi Piani cottura Electrolux EHT7833K