Electrolux EWF147110W Manuale Utente Scaricare il pdf (Pagina 9)

again. If you have chosen a delayed start,

the machine will begin the countdown.

If an incorrect option is selected, the red pi-

lot light of the button 5 blinks for 3 times.

Altering an option or a running

programme

It is possible to change some options be-

fore the programme carries them out.

Before you make any change, you must

PAUSE the appliance by pressing the but-

ton 5.

Changing a running programme is possible

only by resetting it. Turn the programme se-

lector dial to O and then to the new pro-

gramme position. Start the new programme

by pressing the button 5 again. The wash-

ing water in the tub will be not emptied out.

Interrupting a programme

Press the button 5 to interrupt a pro-

gramme which is running, the correspond-

ing green pilot light starts blinking.

Press the button again to restart the pro-

gramme.

Cancelling a programme

Turn the selector dial to

to cancel a pro-

gramme which is running.

You can select now a new programme.

Opening the door

After the programme has started (or during

the delay time) the door is locked, if you

need to open it, set first the machine to

PAUSE by pressing the button 5. After a

few minutes the light 7.2 goes out and it is

possible to open the door.

If this light remains lit and the door is

locked, this means that the machine is al-

ready heating or that the water level is too

high. In any case, do not try to force the

door!

If you cannot open the door but you need

to open it you have to switch the machine

off by turning the selector dial to

. After a

few minutes the door can be opened (pay

attention to the water level and temper-

ature!).

After closing the door, it is necessary to se-

lect the programme and options again and

to press button 5.

At the end of the programme

The machine stops automatically. The pilot

light of button 5, the pilot lights 7.1 and 7.2

go off. The light 7.3 illuminates.

If a programme or an option that ends with

water left in the tub has been selected, the

pilot light 7.2 remains on and the door is

locked to indicate that the water must be

emptied out before opening the door.

Follow the below instructions to empty out

the water:

1.

Turn the programme selector dial to

.

2. Select the draining or spinning pro-

gramme.

3. Reduce the spin speed if needed, by

pressing the relevant button.

4. Press button 5.

At the end of the programme, the pilot light

7.2 goes off to indicate that the door can

be now opened. Turn the programme se-

lector dial to

to switch the machine off.

Remove the laundry from the drum and

carefully check that the drum is empty. If

you do not intend to carry out another

wash, close the water tap. Leave the door

open to prevent the formation of mildew

and unpleasant smells.

Stand by: once the programme has

finished after a few minutes the energy

saving system is enabled with the pilot

lights switched on. By pressing any

button the appliance will come out of

the energy saving status.

HELPFUL HINTS AND TIPS

Sorting out the laundry

Follow the wash code symbols on each

garment label and the manufacturer’s

washing instructions. Sort the laundry as

follows: whites, coloureds, synthetics, deli-

cates, woollens.

Before loading the laundry

Never wash whites and coloureds together.

Whites may lose their «whiteness» in the

wash.

electrolux 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 51 52

Commenti su questo manuale

Nessun commento