Electrolux IH24E Manuale Utente

InstantaneousWater HeaterIH 18 electronic LCDIH 21 electronic LCDIH 24 electronic LCDInstructions for installation and use

10Water connectionThe water inlet temperature on the cold water connection should bemax. 70°C. Upwards of 45°C, the appliance system is arranged not t

11Installation versionsFor fittings directly on the appliance, the bushing openings pre-embossed inthe appliance hood must be cut out for the extensio

12Cleaning the strainer insertIf the water flowrate is reduced by dirt from the cold water line, the strainer-insert should be cleaned as follows:Flow

13Electrical connectionThe electrical connection should only ever be made after the water isconnected! The appliance is only suitable for a fixed conn

14Mains connection underneath (alternative)For this connectionversion, transpose themains connection terminal(1) from top to bottom.Note the terminald

15Temperature selector range limitationThe maximum temperature able to be set can be limited to 40°C or 45°C.Important! Before dismantling, set the kn

16Using the appliance for the first time and checkingThe unit must be installed and started up by an approved firm of installerswhich accepts liabilit

17Check the voltageClean strainer insert (seepage 12)Dismantle and clean thebubblers and showersheadsInspection and repair onlyby the trained engineer

18Fault indications- L1 or L3 phase missing- L2 phase missingFaultpatternIdicator Possible faultsLED 1 LED 21 No displayAppliance does not work- Flowr

19Important for the expertThe electronic controls the safety-function of the appliance. When a fault isnoticed, the fault indicator (LED) blinks and t

2Contents PageImportant instructions for the user 3General 3Operating the appliance 3Temperature preselection 3Hot water flowrate 4Care and maintenanc

Customer serviceIf your appliance has a fault, please contact your customer service centre foradvice.Electric appliances should only ever be repaired

3When the appliance is operated with a thermostatic mixer tap, thetemperature setting on the instantaneous water heater must be around 8°Chigher than

Hot water flowrateUp to the appliance’s max. power limit, the instantaneous water heatersupplies the set hot water temperature regardless of the water

Important instructions for the installerGeneralThe instantaneous water heater is manufactured and tested in conformity withthe valid IEC specification

6Technical data*) In addition to the flow pressures of the instantaneous water heater itself, consideration must be given to the pressure losses in

7Appliance functionThe fully electronically controlled ELECTROLUX IH instant water heater is apressurised appliance for the supply of one or more tapp

8Installing the applianceThe appliance should only ever be installed or stored in frost-freepremises.Dimensioned diagram1 = Quick fastener for applia

9Appliance installationCarefully unpack and take out the enclosed pack.Prepare the appliance for assembly.Hood dismountingPress in the engagement lug